Problem with indirect control using firmware 3.2.5.0 [rev1]

HAPCAN installation tips and troubleshooting when assembling, commissioning and configuring devices.
Rozwiązywanie problemów z instalacją HAPCAN, budową, uruchamianiem i konfiguracją urządzeń.
skagmo
Posts: 3
Joined: 17 Nov 2018, 16:39

Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby skagmo » 17 Nov 2018, 16:42

Hi.

I have a firmware issue with the newer 3-module 3.2.5.x relay.

I have added a simple instruction to turn off a relay channel with a time delay, triggered by a status message reporting that the same relay channel has been turned on. In other words, the channel will turn off with a time delay after being turned on. This never happens.

I'm running firmware 3.2.5.0 [rev1]. The same setup (just with the address changed in the message criteria) works perfectly in a UNIV 3.2.1.x device with firmware 3.2.1.0 [rev1].

indirect control problem.PNG

Jacek
Posts: 476
Joined: 17 Feb 2007, 18:00

Re: Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby Jacek » 19 Nov 2018, 20:21

Hi,
I will have a look at it on weekend.
Can you see this trigger message in HAPCAN Programmer Monitor?
Regards
Jacek

Jacek
Posts: 476
Joined: 17 Feb 2007, 18:00

Re: Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby Jacek » 19 Nov 2018, 20:35

I can see where the problem is. The UNIV 3.2.5.0 firmware is missing these lines: https://github.com/hapcan/UNIV_3.2.1.x/ ... 3.asm#L733

I will correct this on weekend.
Thanks for that.
Regards
Jacek

skagmo
Posts: 3
Joined: 17 Nov 2018, 16:39

Re: Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby skagmo » 20 Nov 2018, 07:13

Thank you for your prompt help, Jacek.

Jacek
Posts: 476
Joined: 17 Feb 2007, 18:00

Re: Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby Jacek » 25 Nov 2018, 22:29

The new UNIV 3.2.5.0-rev2 firmware is available at website now (http://hapcan.com/devices/universal/uni ... /index.htm). Sorry, I haven't tested it. Can you check if everything is alright, please?
Regards
Jacek

skagmo
Posts: 3
Joined: 17 Nov 2018, 16:39

Re: Problem with indirect control using firmware 3.2.5.0 [rev1]

Postby skagmo » 26 Nov 2018, 16:07

Got to test it quickly now. It seems to work and it responds to its own messages, so the issue is resolved. Thanks!


Return to “Technical Support / Wsparcie techniczne”



Who is online

Users browsing this forum: No registered users and 1 guest

cron