DEVICES -> RGB LED CONTROLLER
|
RGB LED Controller
|
· 3 channel LED controller · Maximum load 120VA for each channel · PWM (Pulse Width Modulation) · Controller can generate any colour with required intensity of common anode RGB LED. · Can work with RGB LEDs or three single colour LEDs (eg. LED strips, tapes, tubes etc.) or low voltage bulbs (classical and halogen 12-24V) · Can work as 0-10V driver · Maximum LED supply voltage 12-24V · Maximum LED current 5A for each channel · Operation voltage 10-24V. · Current consumption from the bus 12mA. · For DIN rail mounting. · Dimensions 90x58x53 mm (3 mod)
|
|||||||||
· Voltage control in 256 steps (0-255) for each channel · Channel MASTER changeable in 256 steps as well · Possibility to set up minimum and maximum value for each channel · Last MASTER state memory · Adjustable dimming time for each channel · 33 control instructions · 1s-20h timer for some instruction execution · Allows to set up 128 conditions for receiving bus messages · 3 blocking instructions · Settable Power up value. · Allows to write notes into processor
|
||||||||||
· Same as UNIV 1.0.8.12 - rev 0 exccept: · Allows to set up 96 conditions for receiving bus messages - (conditions 97-128 from previous firmware will not work) · Self health check · Receive and transmit FIFO buffers for CAN
|
