HAPCAN installation tips and troubleshooting when assembling, commissioning and configuring devices.
Rozwiązywanie problemów z instalacją HAPCAN, budową, uruchamianiem i konfiguracją urządzeń.
I have a firmware issue with the newer 3-module 3.2.5.x relay.
I have added a simple instruction to turn off a relay channel with a time delay, triggered by a status message reporting that the same relay channel has been turned on. In other words, the channel will turn off with a time delay after being turned on. This never happens.
I'm running firmware 3.2.5.0 [rev1]. The same setup (just with the address changed in the message criteria) works perfectly in a UNIV 3.2.1.x device with firmware 3.2.1.0 [rev1].