HAPCAN Programmer

SOFTWARE -> HAPCAN PROGRAMMER

	HAPCAN PROGRAMMER version 3.55

	DESCRITPION
	HAPCAN Programmer is the Windows based software which sets up the HAPCAN system. The system can be configured using RS232C or Ethernet interface. The whole setting up process can be done through the system network, or even through the Internet. It means that devices do not have to be preconfigured before installing.

	LICENSE
	freeware

	PLATFORM
	- Windows XP/7/8/10 - minimum resolution 1024x768

	MAIN FEATURES
	- searching for devices on the HAPCAN network; - node basic settings (ID and descriptions); - firmware update of nodes; - node configuration backup and restoring; - monitor tool displays messages sent by nodes on the bus; - read/write/erase/modify/backup/restore eeprom and flash data of UNIV 3 processor. - controls nodes; - sets relationships between nodes;

	CONTROLLED DEVICES
		Button module	Relay module	Infrared receiver/transmitter	Temperature sensor	Infrared transmitter	Dimmer
		UNIV 1.0.1.1 UNIV 1.0.1.21 UNIV 1.0.1.33 UNIV 3.1.0.0 UNIV 3.1.1.0 UNIV 3.1.2.1 UNIV 3.1.3.0 UNIV 3.1.3.1	UNIV 1.0.2.10 UNIV 1.0.2.11 UNIV 1.0.2.23 UNIV 1.0.2.3 UNIV 1.0.2.4 UNIV 3.2.1.0 UNIV 3.2.2.0 UNIV 3.2.3.0 UNIV 3.2.4.0 UNIV 3.2.4.2 UNIV 3.2.4.3 UNIV 3.2.5.0	UNIV 1.0.3.0 UNIV 1.0.3.2 UNIV 3.5.0.1 UNIV 3.5.0.2 UNIV 3.5.0.3	UNIV 1.0.4.0	UNIV 1.0.5.1 UNIV 3.5.0.1 UNIV 3.5.0.2 UNIV 3.5.0.3	UNIV 1.0.6.11 UNIV 1.0.6.22 UNIV 3.6.0.2

		Shutter controller	RGB LED controller	Open Collector Outputs	Ethernet Interface	RS232C Interface
		UNIV 1.0.7.1 UNIV 3.7.0.0	UNIV 1.0.8.12 UNIV 3.8.0.0	UNIV 3.9.0.0	UNIV 2.0.2.3 UNIV 3.102.0.0 UNIV 3.102.0.1	UNIV 3.101.0.1

DOWNLOAD

HAPCAN Programmer
version 3.55

2.59MB

OLDER SOFTWARE

HAPCAN PROGRAMMER 2.91
- software supports a shortened Ethernet and RS232C frames (without start, stop and checksum bytes)

GO TO OLD VERSION